Add and remove clicks

DO NOT FORCE the Clicks into or out of the Base.

The Clicks are designed to insert easily, lock firmly into place and stay put — UNTIL you deliberately release them.

Practice using the Clicks on the Base once or twice before you attach electronics. You’ll quickly get the hang of it and find it is natural and easy to use.

Notice the feet.png

Notice the feet

Each Click has four feet.

The “Locating Feet” are shaped like little shoes. In this photo, they are on the bottom.

The “Locking Feet” have elliptical springs and look like a pillar with a slit through the middle. Squeeze the locking feet gently to watch how the spring works.

Place the Click.png

Place the Click

Keep the locking feet (with the springs) on the side toward you.

Tip the Click and insert the locating feet into any two primary holes. Make sure the locating feet are fully seated in the Base.

Don't squeeze too early.png

No pushing or squeezing!

Just set the locking feet down on the holes of the Base.

Important: do not begin squeezing before the locking feet have settled on top of the holes. If you compress the locking feet too early, the Click will resist insertion.

Squeeze in and press down.png

Lock in place

USING BOTH HANDS, place your thumbs on the locking feet with your fingers on the locating feet, and gently squeeze together, while pushing down.

Once the locking feet drop down into the holes, release the springs. The Click is firmly seated.

At this point the Click will stay firmly attached to the Base until you deliberately release it.

Squeeze and lift up.png

Release the Click

To release an attached Click, turn the Base so that the locking feet of the Click are closest to you.

USING BOTH HANDS, place your thumbs on the locking feet with your fingers on the locating feet, and gently squeeze while lifting up with your thumbs.

Lift the click.png

Lift the Click

Once the locking feet are released, you can easily slide the Click back and up towards you.