Step Five:

Install the Sense HAT

TIP:  The GPIO connector that comes with the Sense HAT is not needed for this project. You may wish to save it for future projects.

6-1.png

Remove the GPIO connector that comes with the Sense HAT. A gentle wiggle should enable you to pull it off. 

Step 5-2 IMG_1437.JPG

Attach the Sense HAT to the extended header. The header pins should not protrude more than 1mm through the top of the Sense HAT. 

Be sure to align all the pins correctly so you don’t bend or damage the header.

Use the M2.5 screws to attach the Sense HAT to the stand-offs below it.

You're almost done!  Go next to Step 6: Complete the Assembly